My GE Profile PVD28BYNBFS ice maker quit. First found ice melting, no new ice. Cleared it out, checked arm bar for malfunctions, water line not pinched, as it filled tray but it's not freezing (blowing cold air in there). Pulled drawers out if freezer, used hair dryer to attempt to thaw possible frozen fan. Hoped that would do it as I've had Turning the power to the refrigerator off for five minutes can also reset the ice maker. Check the refrigerator’s manual for ice maker reset instructions. 4. Check the Mechanical Arm. As mentioned above, if your ice maker has a mechanical arm, it needs to be down for the ice maker to work. The arm can also fail if the arm’s spring has broken. Nov 17, 2021. #5. The new Icemaker is installed with few issues. One bit of advice is to do the replacement while unplugged. If you are just in the forced defrost mode, it may end and go back to cooling before you get the new one in place, and the freezing coil will ice up quickly and prevent easy changeout. Here are some common causes for a Dacor refrigerator not making ice that’s large enough: Low Water Pressure: The refrigerator’s water inlet valve requires at least 20ps of pressure to properly make ice. Check the water pressure to your house to make sure it meets this minimum guideline. Clogged Filter: A dirty filter can restrict the water 1 Toshiba Fridge Not Cooling. 2 Toshiba Refrigerator Stopped Making Ice. 3 Toshiba Refrigerator is Noisy or Loud. 4 Toshiba Refrigerator No Longer Defrosting. 5 Toshiba Fridge Leaking Water. 6 Toshiba Freezer Compressor Switching on Randomly for More Prolonged Periods: 7 Toshiba Freezer Has Strange Noises After Instalment. The easiest problem to solve is one of settings. The ice maker is not obvious when it turns off, and there are sometimes two or three different ways to pause or stop your ice maker. One member of the household could easily have accidentally switched your ice maker into an off state so that it stops making ice entirely. Locate the filter in the fridge, it’s likely in the top right. Press the filter in to release. Take the old filter out, dispose of it, then replace it with the new one. Get a bowl or bottle and dispense 1.5 gallons to eliminate any air in the line and prime the new filter – this will need to be discarded. Turn Ice ON or OFF Using Panel Controls. 3. If you recently changed the water filter, press the Alarm button and hold for 3 seconds to reset the water filter. (The color of indicator changes from red to blue, green, or yellow) 4. If the Refrigerator door is open, the ice and water dispenser will not work. .

mitsubishi fridge ice maker not working